Home-Knowledge-

Content

Cold Rolled Steel Coil Grades Explained: SPCC, DC01-DC07 & Equivalents

Jan 18, 2024

1. Why Grade Designations Matter

2. The JIS G 3141 System: SPCC, SPCD, SPCE, SPCF, SPCG

3. The EN 10130 / GB/T 5213 System: DC01-DC07

In the European EN 10130 standard - and the closely aligned Chinese standard GB/T 5213 - the designation starts with D for flat products for cold forming; the C identifies a cold rolled (cold-reduced) product; and the two following digits indicate the forming level. DC01 is commercial quality, DC03 drawing quality, DC04 deep drawing quality, and DC05, DC06 and DC07 are progressively deeper non-aging deep drawing qualities. Note that the digits are sequence numbers, not property values: the standard tables give the actual yield strength, tensile strength and elongation limits for each grade. In practice, DC01 is the workhorse for general fabrication, DC03/DC04 cover stamped appliance and furniture parts, and DC05-DC07 are specified for automotive panels and other severe draws where aging resistance and r-value (plastic strain ratio) consistency matter.

4. Cross-Standard Equivalents and Comparison

Formability level JIS G 3141 EN 10130 GB/T 5213 ASTM A1008
Commercial quality SPCC DC01 DC01 CS
Drawing quality SPCD DC03 DC03 DS
Deep drawing quality SPCE DC04 DC04 DDS
Extra deep drawing, non-aging SPCF/SPCG DC05-DC07 DC05-DC07 EDDS

Equivalents are approximate: each standard has its own tolerance, chemistry and testing rules, and grades from different systems are not automatically interchangeable. When a contract specifies one standard, the coil and its mill certificate should be supplied to that same standard.

5. How to Choose the Right Grade

Frequently Asked Questions

Q: What is the difference between SPCC and SPCD?
A: Both are JIS G 3141 cold rolled grades, but SPCD is a drawing quality with a yield-strength ceiling and better ductility, so it forms deeper parts without cracking; SPCC is commercial quality for general forming.

Q: Is DC01 the same as SPCC?
A: They occupy the same formability level in different standards (EN 10130 vs JIS G 3141) with broadly similar properties, but they are not automatically interchangeable. Specify the grade against the standard your contract requires.

Q: What does non-aging mean in SPCF/SPCG and DC05-DC07?
A: It means the steel chemistry is stabilized (for example with titanium or niobium additions) so that yield strength and formability do not degrade during storage, which is important for parts stamped weeks after the coil is produced.

Q: Which grade do I need for a washing machine outer shell?
A: A drawing quality such as SPCD or DC03/DC04 is typical, because the shell is a deep draw with visible surfaces that must not split or show Luders lines.

Q: Do higher grades always cost more?
A: Yes. Deep drawing and non-aging grades use cleaner steel chemistry and tighter process control. Buying a higher grade than the part needs adds cost without benefit; the goal is to match grade to forming severity.

Q: How can I verify the grade I receive?
A: Request the mill test certificate showing the standard, grade, chemistry and mechanical test results, and check the coil edge markings or labels. Third-party inspection with tensile and hardness testing can verify compliance before shipment.

SEND INQUIRY

SEND INQUIRY