Home-Knowledge-

Content

SPCE Cold-Formed Cold-Rolled Steel: Flat Products

Feb 19, 2024

Introduction

This article explains SPCE cold-formed cold-rolled mild steel flat products. SPCC, SPCD and SPCE are Japanese cold-rolled steel grades defined in JIS G3141, with SPCEN as the deep-drawing quality. The series parallels the EN DC grades: SPCC is the general grade, SPCD is for drawing and SPCE for deep drawing, and the corresponding German designations ST12 and ST14 are used for the same products.

Grade System

SPCC stands for steel plate cold commercial, SPCD for cold drawing and SPCE for cold deep drawing, with SPCEN carrying a guaranteed non-aging property for severe forming. The ST12 and ST14 designations under DIN 1623 are the German equivalents of the general and deep-drawing grades, and the grades are widely cross-referenced in international trade.

Mechanical Properties

Formability increases from SPCC through SPCD to SPCE, shown by falling yield strength and rising elongation. The guaranteed values depend on the thickness range, and the temper of the delivered coil is specified by the surface and forming requirement of the application.

Grade Forming Class Equivalent Typical Use
SPCC Commercial DC01, ST12 General stamping
SPCD Drawing DC03, ST13 Drawn housings
SPCE Deep drawing DC04, ST14 Deep-drawn parts
SPCEN Non-aging DC05/DC06 Severe forming

Applications

SPCC is used for general stampings, chassis parts, enclosures and lightly formed panels; SPCD for drawn housings and structural parts; SPCE and SPCEN for deep-drawn components such as oil pans, lamp housings and appliance shells. SECC is the electro-galvanized version of SPCC for corrosion-resistant applications.

Selection and Verification

Match the grade to the forming severity and surface requirement, and verify the mechanical properties, thickness and surface finish on the mill certificate against JIS G3141.

FAQ

1. What does SPCC stand for? Steel plate cold commercial, the general-purpose cold-rolled grade in JIS G3141.
2. What is the difference between SPCC, SPCD and SPCE? The forming severity increases from commercial through drawing to deep drawing quality.
3. What is SPCEN? A deep-drawing grade with guaranteed non-aging properties for severe forming.
4. What are ST12 and ST14? German designations under DIN 1623 for general and deep-drawing cold-rolled steel.
5. What is SECC? Electro-galvanized SPCC for corrosion-resistant applications.
6. Which standard defines these grades? JIS G3141 for the SPCC series.
SEND INQUIRY

SEND INQUIRY