Home-News-

Content

Factors Affecting The Rust Of Color Coated Sheets

Feb 19, 2024

In short, rust damage to color-coated steel plates is mainly caused by rusty cast iron parts, such as rusty steel nails and wires falling on the surface of color-coated thick steel plates, and color-coated, thick steel plate surfaces that have been coated for a period of time. damage caused. Rust is an infectious disease that also explains iron castings. This is because rust is honeycomb-shaped and can easily digest water. The digested rust will accelerate the corrosion of cast iron parts. The corrosion of cast iron adheres to the color-coated thick steel plate, causing corrosion of the color-coated coil thick steel plate.

 

temperature

The coating becomes softer, and corrosive solvents are easy to adhere and penetrate into the substrate. The oxygen content in the water will increase under continuous high temperatures, and the corrosion rate will accelerate at a certain temperature.

ppgi

environment humidity

Substrate corrosion at wounds and processing damage is electrochemical corrosion, and low humidity will not easily form a corrosion cell (i.e. electrochemical circuit).

 

Temperature difference

Large temperature differences make it easy for condensation to form, creating conditions for galvanic corrosion on exposed metal. In addition, large temperature differences also cause frequent hot and cold deformation of the coating, which will accelerate the aging and loosening of the coating, and external corrosive solvents can easily penetrate into the substrate.

 

sunshine

UV ultraviolet spectrum is a high-frequency ray, which has greater impact than low-energy spectrum. X-rays have a penetrating effect, and gamma rays can break chemical bonds and produce free charged ions, which are fatal to organic matter. Therefore, it can be seen from the above that the sunshine hours and strength affect the structural stability of the coating, especially in areas with strong ultraviolet light.

Colour Coated Roofing Sheet

precipitation

Precipitation with high acid value will indeed corrode steel. However, precipitation has a dual effect. For wall panels and roof panels with a large slope ratio, it can clean the surface of the steel plate and wash away surface corrosion. However, for roof panels with a low slope ratio and poor drainage pipes, Location, the greater the precipitation, the more likely it is to cause increased corrosion.

 

Wind frequency

Like water, and often associated with it, it is a test for the joints of materials because wind can cause joints to loosen and precipitation can seep into the interior of the building.

 

Corrosive substances

Corrosion sediments such as chloride ions, sulfur dioxide, etc. can accelerate corrosion. Such sediments are often caused by seaside and areas with serious environmental pollution (such as power plants, smelting plants, etc.).

 

join

There are usually varieties such as lap, undercut and buckle. The material selection of fasteners requires that its corrosion resistance is better than that of colored steel plates. Otherwise, according to the principle of large cathode and small anode, the connection will corrode and wear out quickly. Secondly, the product quality of the sealant must be ensured.

 

towards

The orientation and slope of a building affects the number of hours of sunshine and therefore the durability of the coating. The slope ratio also affects the settling time of corrosive solvents or dust on the steel plate.

SEND INQUIRY

SEND INQUIRY