1. What DC07 Is
DC07 is the highest formability grade among the cold rolled flat products for cold forming defined in EN 10130. It is an aluminium killed, fully stabilised, ultra low carbon steel supplied in the annealed and skin passed condition. In practical terms it is the material chosen when a part must be stretched and drawn far beyond what DC04 or DC05 can survive without splitting.
2. Where It Sits in the Grade Range
The EN 10130 series runs from DC01 for general forming through DC03 and DC04 for drawing, DC05 and DC06 for extra deep drawing and finally DC07 for the most severe operations. Each step upward raises the plastic strain ratio and the strain hardening exponent while lowering the yield strength and carbon content, which together delay the onset of necking and fracture. DC07 has the lowest residual carbon and the most favourable crystallographic texture of the series, which is what gives it its exceptional drawing behaviour.
3. Why Manufacturers Choose It
Complex parts such as automotive inner panels, fuel tank shells, filter housings, sink bowls and deep appliance components fail in the press when the material cannot distribute strain evenly. DC07 tolerates large draw depths, tight radii and high blank holder forces, which reduces scrap, shortens tool try out and cuts the number of intermediate annealing steps. Its stable, non ageing behaviour also means coils can be stored for months without losing formability, an important benefit for just in time supply.
4. Forming and Processing Notes
DC07 is soft, so it marks easily and needs clean handling and adequate lubricant. Springback is low but blank holder pressure must be controlled, because the material wrinkles readily when restraint is too light. Welding is straightforward for aluminium killed low carbon steel, and the grade accepts paint, enamel and galvanizing well when the surface is correctly prepared.
5. Practical Selection Advice
DC07 is a premium product and should be reserved for parts that genuinely need it. If a component can be produced from DC04 or DC05 at an acceptable scrap rate, the lower grade will normally be more economical. Where DC07 is justified, agree the mechanical property range, the surface quality class and the oiling condition with the supplier, and validate the forming process with sample coils before production.
Frequently Asked Questions
Q: Is DC07 the same as DC06?
No. DC07 is a step beyond DC06 in formability, with lower carbon and a stronger favourable texture, and it is reserved for the most severe forming operations.
Q: What does aluminium killed mean?
It means the steel was fully deoxidised with aluminium during melting, so it is free of the ageing behaviour that affects rimmed or unkilled steels.
Q: Does DC07 rust easily?
DC07 is an uncoated cold rolled steel, so it needs oiling for storage and a paint, enamel or metallic coating for long term corrosion protection in service.
Q: Can DC07 be used for structural parts?
No. DC07 is designed for formability rather than strength, so load bearing parts should use a structural grade instead.
Q: What should I check on the mill certificate for DC07?
Confirm the standard, the grade, the yield and tensile strength, the elongation, the plastic strain ratio and the surface quality class.


