Home-Knowledge-

Content

Cold-Rolled Steel Sheet: Uses, Grades and Applications

Feb 05, 2024

1. What Cold Rolled Steel Sheet Is

Cold rolled steel sheet is produced by rolling hot rolled pickled coil at room temperature, which gives a thinner gauge, tighter thickness tolerance, a smoother surface and better mechanical properties than hot rolled material. Because the steel is strain hardened during reduction, it is normally supplied in the annealed and skin passed condition so that formability is restored and the yield point is stabilised.

2. Main Grades

The most common commercial grades in EN 10130 are DC01 for general forming, DC03 and DC04 for deeper drawing, DC05 and DC06 for extra deep drawing, and DC07 for the most severe forming operations. The older DIN designations SPCC, SPCD and SPCE are still widely quoted and correspond broadly to commercial, drawing and deep drawing quality. Structural and high strength cold rolled grades are available where strength rather than formability is the governing requirement.

3. Applications by Industry

Automotive bodies, panels, seat frames and brackets are the largest single use. Domestic appliances such as washing machine drums, refrigerator panels, ovens and air conditioner housings consume large volumes. The construction sector uses cold rolled sheet for doors, partitions, ceiling grids, steel furniture and ducting. Electrical enclosures, cabinets, cable trays and transformer components represent another significant demand. Packaging, drums and general stamping complete the picture.

4. Selecting Thickness and Surface

Cold rolled sheet is commonly supplied from about 0.3 to 3.0 millimetres thick. Surface quality classes range from normal to extra improved for visible parts, and finishes may be matt, bright or extra bright depending on the annealing and temper rolling conditions. Buyers should also agree the oiling requirement, since a light protective oil film guards the surface against rust during storage and shipment.

5. Buying Checklist

Confirm the grade, thickness and width tolerance, the surface quality class, the temper rolling condition and the oiling requirement before ordering. A mill test certificate showing chemical composition and mechanical properties should accompany every coil or sheet consignment, and forming trials are recommended before committing to a large volume.

Frequently Asked Questions

Q: What is the difference between SPCC and DC01?
Both are general purpose cold rolled grades; SPCC comes from the Japanese JIS tradition and DC01 from EN 10130, and they are broadly interchangeable for ordinary forming.

Q: Why is cold rolled sheet more expensive than hot rolled?
It goes through additional pickling, cold reduction, annealing and temper rolling steps, which cost more but deliver tighter tolerances and a better surface.

Q: Which grade should I use for a deep drawn part?
Start with DC04 for moderate drawing and move to DC05, DC06 or DC07 as the draw depth and complexity increase.

Q: Does cold rolled sheet need oiling?
Oiling is not mandatory for every use but it is strongly recommended when coils will be stored for a long time or shipped in humid conditions.

Q: Can cold rolled sheet be galvanized?
Yes, clean cold rolled strip is a common substrate for hot-dip galvanizing, and it is also supplied already coated as GI coil.

SEND INQUIRY

SEND INQUIRY