1. What a GI Coil Is
A GI coil, more precisely a hot-dip zinc coated steel coil, is steel strip that has passed through a bath of molten zinc in a continuous galvanising line. The solidified zinc coating protects the base steel by acting as a barrier and by sacrificing itself at scratches and cut edges. The same looking coil can be produced to very different standards, coating masses and surface qualities, so the grade designation on the mill certificate is the buyer's first and most important check.
2. The JIS G 3302 Family
Under JIS G 3302 the grade name reflects the substrate and the formability class. SGCC is commercial quality zinc coated steel on a cold rolled substrate and is the most widely used general purpose grade. SGCD1 through SGCD4 are drawing qualities with progressively better formability. SGHC denotes zinc coated steel on a hot rolled substrate, chosen when a heavier gauge or lower cost matters more than surface finish. Coating mass is specified separately with a symbol such as Z27 for 275 grams per square metre total on both sides.
3. The EN 10346 and GB/T 2518 Families
EN 10346 uses DX for coated flat products for cold forming followed by a formability number, so DX51D is the general purpose grade and DX52D to DX57D cover progressively deeper drawing. Structural grades in the same standard carry an S prefix and a minimum yield strength, for example S220GD up to S550GD. GB/T 2518 mirrors this logic with the DC51D to DC57D series for coated cold forming grades, so a quotation that cites DC51D is using the Chinese standard while DX51D is the European equivalent.
4. Coating Mass, Spangle and Surface
Coating mass designations such as Z100, Z140, Z275 and Z350 state the total zinc weight on both sides and are the practical measure of corrosion life. Spangle can be regular, minimised or skin passed to a spangle free finish, and surface quality classes control the number of permissible defects for exposed or painted use. Chromate free passivation and oiling are common surface treatments that affect handling, storage and paint adhesion.
5. Choosing the Right Grade
For simple bending and general fabrication, SGCC or DX51D with a moderate coating mass is usually sufficient. Deeply formed parts call for SGCD or DX53D and above. Where a structural calculation governs, a grade from the S series should be selected so that yield strength is guaranteed rather than assumed. Buyers should always confirm substrate, formability class, coating mass, spangle and surface quality together before placing an order.
Frequently Asked Questions
Q: Is SGCC the same as DX51D?
They are similar general purpose grades from different standards; SGCC is defined in JIS G 3302 and DX51D in EN 10346, and the closest Chinese equivalent is DC51D in GB/T 2518.
Q: What does Z275 mean on a GI coil?
It means a total zinc coating mass of 275 grams per square metre, counting both sides of the strip.
Q: When should I choose SGHC instead of SGCC?
Choose SGHC when the part is made from a hot rolled substrate, usually for heavier gauges or when a lower cost matters more than a fine surface finish.
Q: Does spangle affect corrosion performance?
Spangle is mainly a cosmetic and paint adhesion issue; corrosion life is governed far more by coating mass than by the visible crystal pattern.
Q: What should a mill certificate for GI coil contain?
It should state the standard, the full grade including the coating symbol, chemical composition, mechanical properties, coating mass and surface quality class.


